Goddammit fat finger on phone
How do I fix this
Hunter Gonzalez
Jason Diaz
I always hated the wheeler one, but if it works for you that's what counts. So did that happen during firing or what?
Matthew Carter
Hey OP if you can please take a pic of the upper at an overhead angle I want to see how they attached the rail to the plastic. I've seen a shrubmaster with what looks like two really stubby flat head screws holding it place. I especially want to know since I can't see how they kept them together without assuming it's glue or some kind of dovetail thing.
Jordan Butler
Pounded it back into place with a nylon hammer, is not attached at all on the back dropped it from waist height and it just popped off gonna go rezero it on sunday
Levi Peterson
Just hold really low
Aaron Brooks
Do you have a petroleum jelly on your phone's camera or what?
William Young
They and PSA cut corners which impact QA and resulted in the offset buffer retainer pin due to their trained monkeys drilling the hole out of place.
Worst case scenarios involve trigger assembly/safety/mag release holes not lining up or being undersized, upper receiver pivot pin lugs breaking off, and the interior of the magwell being under/oversized.
The majority come out just fine, but they have way too many problems to be acceptable.
Hudson Perez
Epoxy, the same way it was glued on in the first place. Boy that is a shitty AR…
Lincoln Anderson
man these #oneless guys are getting weirder and weirder
Isaac Harris
get a real gun amerimutt