80% lower receivers in Germany

any euro country freely sell bolts and barrels?

IIRC that was the case up until some number of years age. You were supposedly able to get legal parts from a number of different countries and make a complete gun with it.
It think they have fixed it now, but not sure.

Rohr und Verschluss, bitte.

double check again pls.

t. Bernd

Eher:
t.hat gedient

Beides inkorrekt.
Der Lauf ist der Teil einer Schusswaffe, welcher der Führung des Projektils dient und den das Projektil während des Schusses "durchläuft".
Das Rohr ist der Lauf einer Schusswaffe+Patronenlager.
Genau so sind der Bolzen und der Verschluss zwei verschiedene Teile, der Verschluss schließt das Rohr nach hinten ab, während der Bolzen der Metalschift ist der auf das Zündhütchen der Patronen schlägt.
Je nach Bauart der Schusswaffe können beide ineinander integriert sein, müssen es aber nicht.

Attached: Lauflange_Rohrlange_Waffe.png (1788x596, 19.17K)

Not giving any legal advice here. AFAIK, Germany considers the barrel and parts that enable the firing itself as regulated. The receiver is not part of the firing mechanism as such and should not be registered. Go ask a lawyer or gunsmith for hands on info.

Ill ask again to try my luck here. I have all this fucking bitcoin and nothing to spend it on.
Is there a single 80% lowers dealer who accepts bitcoin?
I found one willing to ship 1911 frames, jigs and everything just they dont accept bitcoin.

But isn't the lower like the most easily "acquired" part of the gun? Barrel, upper and bolt etc is much harder to manufacture. It's not like you're gonna switch out the lower on your rifle for any reason so unless you plan on bringing it to the states we are much worse off.