First AR

Did you use a hand drill jig or something?

What fucking handguard did you use? Some poorfag airshitter thing from aliexpress? Plastic handguards with heat shields will not melt under nor al circumstances and deal with heat better than any metal handguard including those all holes rails being sold for over 300.

Okay holup. You put the spring detent side of the TG towards the pistol grip but the side with a hole going through, you put it on the side with a hole on only the right side correct? Is there a big chunk of roll pin sticking out or did you some how get it flush. If it still sticks out just get to work on it with a pair of pliers that will get you a good grip like groove joints or vise grips. If it is flush dont worry and just use the hand drill with a smaller bit if you're scared of yoking out the hole and start moving up in size from there. Hopefully you don't twitch like a crack nigger but a good vise will help you well especially if you can set it side ways so you can anchor your hand on a solid surface while working.

Fuck off lad

Tried that already; not enough sticks out and now it's just mushed – nothing that can grip it.

Do you just not read books? These are paragraphs, strelok. I'm writing prose here.

And instantly my mind goes to a hypothetical case where I'm posting at length about tho mongol hordes of ancient times, and the resulting discussion needs must be pointed out to be a discussion of the prose and kahns.

5D Tactical's jig and makita 6.5-amp router, plus yes a hand drill for the FCG holes.

Attached: MakeItA.jpg (400x400, 11.88K)

Try and get military surplus 556. I've gotten mine down to 1 inch groupings at 200 yards with an Aipa Optics scope that I picked up for $100. They stay that way until I start the second mag, then the barrel heats up. Also look into a receiver shim.

Stop digging lad, you're only making the hole deeper. Your post deserves at best two paragraphs, not seven.

you've obviously never shot an AR to any serious extent, you stupid piece of shit.

MBT